Latest market news

Ukraine extends scrap export duty for five years

  • Market: Metals
  • 30/04/21

Ukraine's parliament has approved a bill to extend the country's ferrous scrap export duty for another five years to September 2026. President Vladimir Zelensky has not yet accepted or rejected the bill.

Ukraine's scrap export duty was a point of contention when the country was working towards joining the World Trade Organisation (WTO), which it finally did at the beginning of 2008. The EU refused to endorse Ukraine's WTO membership unless the country agreed to reduce or remove its scrap export duty, which was at €35/t at the time. Ukraine subsequently agreed to cut the duty to €10/t for six years from the date of accession.

Ukraine increased its ferrous scrap export duty to €30/t in September 2016 and gradually increased it to the current level of €58/t in September 2019. An extension of the duty at the current price was submitted in early March, following discussions at the beginning of this year and a request from Ukrainian steelmakers in mid-February. The parliament's committee on environmental policy and management endorsed the extension proposal in early April.

The parliament said that an extension to the current duty system is required to limit scrap exports and support shipments to domestic steelmakers. And if the duty is removed, steelmakers may face a scrap shortage of around 23pc in a year's time. The introduction and gradual increases of the export duty reduced the domestic scrap shortage to zero in 2018 from 300,000t in 2017 and around 600,000t in 2015, demonstrating the need for the export duty, parliament said.

It estimated that the extension will create a fiscal revenue of around 1bn hryvnias/yr ($36mn/yr), because "scrap remade into finished steel products and then exported costs more than just exported scrap".

But scrap market participants disagreed with the economic rationale of the extension. Domestic scrap collection decreased by almost 39pc in 2015-20 to just above 3mn t from 4.3mn t. And scrap exports collapsed to just 26,400t from 1.21mn t over 2015-20, while delivery to steelmakers fell to 2.89mn t from 3mn-3.32mn t. This suggests that the elimination of the scrap shortage was the result of mills' lower requirements amid falling steel output and demand rather than reduced exports (see table)

. The number of scrap recycling companies in Ukraine fell to 900 today from around 1,800 in 2015, industry association UAVtormet said.

Meanwhile, higher scrap prices and robust trading activity supported Ukrainian scrap prices in the first quarter of this year, market participants said. The country's ferrous scrap exports more than quadrupled on the year to 49,000t in January–March. The rise in seaborne scrap prices made export shipments more attractive to suppliers, despite the export duty, and forced Ukrainian mills to pay higher prices in the domestic market.

The increase in domestic prices lifted steelmakers' receipts of ferrous scrap by 23.1pc on the year to 837,700t in January-March — far exceeding their scrap requirements as the country's steel production dipped by 0.5pc year on year to 5.29mn t in the first quarter. Ukraine's scrap collection also increased to 930,000t in January-March, up by 28.2pc on the year.

Besides Ukraine, Russia has also made plans to implement stricter export restrictions for scrap while Kazakhstan reinstated a ban on exports by truck. Both countries' restrictions were introduced after intensive lobbying by steelmakers despite protests from the scrap recycling industry.

Ukraine's steel output and shipmentst
20202019201820172016±% 2020/2016
Production
Crude steel20,616,00020,748,00021,000,00021,417,00024,236,000-14.9
Pig iron20,423,00020,066,00020,560,00020,147,00023,612,000-13.5
Rolled steel products18,427,00018,214,00018,361,00018,441,00021,490,000-14.3
Shipments
Domestic3,676,0003,278,0003,946,0003,856,0003,781,000-2.8
Imports1,227,9001,419,0001,442,0001,302,0001,056,20016.3
Consumption4,903,9004,697,0005,388,0005,158,0004,837,2001.4
Exports14,751,00014,936,00014,415,00014,585,00017,709,000-16.7

Sharelinkedin-sharetwitter-sharefacebook-shareemail-share

Related news posts

Argus illuminates the markets by putting a lens on the areas that matter most to you. The market news and commentary we publish reveals vital insights that enable you to make stronger, well-informed decisions. Explore a selection of news stories related to this one.

News
21/11/24

US alleges Nippon dumped HRC at higher rates

US alleges Nippon dumped HRC at higher rates

Houston, 21 November (Argus) — The US government alleged that Japanese steelmaker Nippon Steel dumped hot-rolled (HR) flat steel products at higher rates than previously determined. The US Department of Commerce's International Trade Administration (ITA) determined that during the period from October 2022 through September 2023, Nippon sold HR steel flat products with a weighted-average dumping margin of 29.03pc, up from the 1.39pc dumping margin the ITA determined for the prior period of October 2021 through September 2022. Tokyo Steel Manufacturing, which was also investigated, was determined to have not sold HR flat steel below market value, unchanged from a prior review. US imports during the period from October 2022 through September 2023 of the investigated items from Japan were 202,000 metric tonnes (t), down from the 293,600t imported in the same period the prior year, according to customs data. The original investigation into imports of Japanese flat-steel products was concluded in 2016. The ITA is now reviewing the time period of October 2023 through September 2024 and expects to issue the final results of these reviews no later than 31 October 2025. The US imported 235,700t of the investigated products from Japan during that time, customs data showed. By Rye Druzchetta Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

Find out more
News

Recent deep-sea and short-sea cfr Turkey scrap deals


21/11/24
News
21/11/24

Recent deep-sea and short-sea cfr Turkey scrap deals

London, 21 November (Argus) — A summary of the most recent deep-sea and short-sea cfr Turkey ferrous scrap deals seen by Argus. Ferrous scrap short-sea trades (average composition price, cif Marmara) Date Volume, t Price, $ Shipment Buyer Seller Composition Index relevant 19-Nov 5,000 345 November Izmir Greece HMS 1/2 80:20, shred Y 19-Nov 2,000 342 November Izmir Malta HMS 1/2 80:20, shred Y 12-Nov 3,000 348 November Izmir Romania HMS 1/2 80:20 N 12-Nov 5,000 350 November Izmir Croatia HMS 1/2 80:20 N 12-Nov 5,000 350 November Turkey France HMS 1/2 80:20 Y 12-Nov 10,000 351 November Marmara France HMS 1/2 80:20 Y Ferrous scrap deep-sea trades (average composition price, cfr Turkey) Date Volume, t Price, $ Shipment Buyer Seller Composition Index relevant 20-Nov 40,000 345 (80:20) December Marmara Scandinavia HMS 1/2 80:20, shred, bonus Y 20-Nov 20,000 340 (80:20) December Iskenderun UK HMS 1/2 80:20 Y 19-Nov 30,000 344 (75:25) December Izmir Cont. Europe HMS 1/2 80:20, bonus N 19-Nov 40,000 353 (80:20) December Iskenderun USA HMS 1/2 80:20, shred, bonus Y 15-Nov 40,000 354 (80:20) December Iskenderun Cont. Europe HMS 1/2 80:20, shred, bonus Y 15-Nov 40,000 356 (80:20) December Marmara Cont. Europe HMS 1/2 80:20, shred, bonus Y 14-Nov 20,000 350 (80:20) November Iskenderun UK HMS 1/2 80:20 N 13-Nov 40,000 356 (80:20) December Marmara Cont. Europe HMS 1/2 80:20, shred, bonus Y 13-Nov 40,000 353 (80:20) December Marmara Cont. Europe HMS 1/2 80:20, shred, bonus Y Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

News

Japan’s crude steel output drops further in October


21/11/24
News
21/11/24

Japan’s crude steel output drops further in October

Tokyo, 21 November (Argus) — Japan's crude steel production in October fell on the year for an eighth straight month, partly because of lower steel demand from the construction sector. The country produced 6.9mn t of crude steel in October, down by 7.8pc from a year earlier, according to preliminary data released by industry group the Japan Iron and Steel Federation (JISF) on 21 November. Crude steel production by basic oxygen furnace (BOF) fell by 6.8pc on the year to 5.1mn t, marking the eighth consecutive month of year-on-year fall. Crude steel output by electric arc furnace (EAF) declined for a third straight month by 10.5pc to 1.8mn t. A double-digit output fall by EAF is partly reflecting the weaker steel demand in the construction sector. The country's steel demand is heavily dependent on the automobile and construction sectors, and steel products for each industry are generally produced using the BOF and EAF methods respectively. Booked orders of ordinary steel for construction use in September fell by 11.3pc on the year to 651,035t, marking the fourth consecutive month of year-on-year decline, according to the separate data released by JISF on 18 November. The country's major steel producer JFE on 6 November revised downward its crude steel output to 22.4mn t for the current fiscal year ending 31 March 2025. This is 600,000t lower than its initial figure announced in August, partly owing to weaker than anticipated steel demand from the construction sector, according to the steel company. Rising material costs and labour shortages are causing delays in major construction projects, JFE said, adding that lower steel demand in the construction industry is "becoming even more obvious.". By Yusuke Maekawa Japanese ferrous output ('000't) Oct '24 Sep '24 Oct '23 m-o-m ± % y-o-y ± % Crude steel production Ordinary steel 5,328 5,098 5,792 4.5 -8.0 Specialty steel 1,597 1,525 1,719 4.7 -7.1 Total crude production 6,925 6,623 7,511 4.6 -7.8 Crude steel production method Basic oxygen furnace 5,101 4,794 5,473 6.4 -6.8 Electric arc furnace 1,824 1,829 2,038 -0.3 -10.5 Pig iron production 5,075 4,802 5,405 5.7 -6.1 Source: Japan Iron and Steel federation *Based on preliminary data Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

News

ArcelorMittal could close two service centres in France


20/11/24
News
20/11/24

ArcelorMittal could close two service centres in France

London, 20 November (Argus) — Europe's largest steelmaker ArcelorMittal is contemplating closing two service centres in France as part of a restructuring at its Centres de Services business in the country. The company informed staff on Tuesday that it might close its Reims and Denain sites because of a "sharp drop in activity among its industry and automotive customers", the company told Argus . Negotiations with trade unions will begin shortly, it said. Rumours about the potential closures have been circling since just before a large industry event in Hannover, Germany, in late October. Further consolidation and restructuring is expected throughout the European service centre market because of the fall in real consumption, and the difficult financial position it has caused for some processors. Most service centres have been selling processed sheet at a loss in recent months, because of weak end-consumption. German cold-roller Bilstein, that sells predominantly to the automotive industry, will reduce headcount and is contemplating closing one of its five lines, or reducing shifts across its business. There have also been market discussions about ArcelorMittal selling other automotive-facing service centres in Europe, as part of a wider reorganisation of the EU processing sector. Germany's largest steelmaker, ThyssenKrupp, has closed some of its distribution sites in its home country. Participants note the service centres are not part of ThyssenKrupp Steel Europe, which is still in talks with Daniel Kretinsky over taking a 50pc share in the business. ThyssenKrupp's ownership change could have wider ramifications for the service centre and steelmaking sector in general, with Kretinsky open to finding a strategic partner. By Colin Richardson Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

News

Graphjet launches Malaysian biomass-to-graphite plant


20/11/24
News
20/11/24

Graphjet launches Malaysian biomass-to-graphite plant

Singapore, 20 November (Argus) — Nasdaq-listed Graphjet Technology has started operations at its artificial graphite plant in Malaysia, which will produce battery-grade graphite using recycled palm kernel shells (PKS), the firm said on 19 November. Graphjet's facility has the capacity to produce 3,000 t/yr of graphite by recycling up to 9,000 t/yr of PKS, which is sufficient to produce batteries for 40,000 electric vehicles (EVs)/yr. The firm has already received its first shipment of PKS, it said. Graphjet has another artificial graphite production facility planned in US' Nevada, and it plans to produce hard carbon at the Malaysian facility to use as feedstock at the Nevada facility. The Nevada facility is expected to have the capacity to recycle 30,000 t/yr of PKS to produce 10,000 t/yr of battery-grade artificial graphite and is slated to begin production in 2026, said Graphjet in April. China, the dominant producer of graphite, added a number of graphite products into its export licensing scheme at the end of last year. The move back then alarmed its neighbours, Japan and South Korea , which are major battery-producing countries and they have since been looking to reduce their dependency on Chinese graphite. China's graphite flake exports fell by 23pc to 44,103t during January-September following the exports curb, according to Chinese customs data. By Joseph Ho Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

Generic Hero Banner

Business intelligence reports

Get concise, trustworthy and unbiased analysis of the latest trends and developments in oil and energy markets. These reports are specially created for decision makers who don’t have time to track markets day-by-day, minute-by-minute.

Learn more